Terms of Use

Last updated: November 18, 2026

By using the ElecMath website you agree to these terms.

A planning aid

ElecMath calculates voltage drop, ampacity and wire sizes only from the numbers you enter, with the K method, NEC Table 310.16 values and standard rounding. It is not an engineering calculation and does not replace the code in force where you work, the equipment instructions, a licensed electrician or engineer, or your inspector. AC results ignore reactance and power factor, which matters most on wire larger than 1/0. It does not include ambient temperature correction, conductor bundling adjustment or the exceptions in NEC 240.4(G). Always check with your local code and inspector before you install.

Trademarks

NEC® and National Electrical Code® are registered trademarks of NFPA; this site is not affiliated with NFPA.

No warranty

The site is provided "as is". We don't guarantee that it is error-free or always available.

Limitation of liability

To the extent the law allows, we aren't liable for indirect or consequential damages, or for any loss that results from using a result of this site.

Changes

We may update these terms; the date above shows the latest version. Using the site after a change means you accept the new terms.

Contact

support@elecmath.com